DENNY'S GUNS ULTIMATE BILLET LOWER RECEIVER WITH STAINLESS BUSHINGS

<< Previous in UPPER RECEIVERS

Next in UPPER RECEIVERS >>

Your Price: $325.00

Sale Price: $311.00

You Save: $14.00 (4 %)

Item Number: DGAR16BBUSH

Manufacturer: GTS/Dennys Guns

Quantity:

Add to a new shopping list

Email this page to a friend

My new "ULTIMATE" Billet lower with Stainless Steel Bushings for the Hammer/Trigger pin holes. Surgical Stainless Steel Hammer/Trigger Pins furnished with the receiver are a unique Non-Rotational design. The Non-Rotational feature is accomplished by machining hex heads on one side of the hammer and trigger pins and machining hex reliefs in one side of the stainless bushings that are screwed into the receiver. An elegant and simple design.

With the new design you will get the absolute most out of your trigger and never experience any trigger or hammer pin wear in this receiver. These units are pre-installed and assembly of your lower is the same as any convetional AR15/M16 platform.

Elegance of design and transparent to the assembler/end user.

Features:

1. Billet Machined
2. 7075 Allow (Not 6061)
3 Stainless Steel Busings in the Hammer/Trigger Pin Holes
4. Surgical Grade Stainless steel Non-rotational Hasmmer Trigger Pins.
5. EDM Machined Magwell
6. Laser Engraved
7. No Pistol / Rifle Designation
8. No Caliber Marking
9. Machined Trigger Guard
10. Upper Receiver Tensioning
Screw
11. Rear Detent Spring Capture Screw
12. Reinforced Critical StrengthAreas
13. Hand Finished
14. Milspec Type III Hard Anodized
15. Markings Laser Engraved in White
16. Serialized on the pistol grip tang also
17. Marked "SAFE" and "SEMI"
18. Low Shelf
19. Got a Magwell Ray Charles could hit.

If you are going to build your "Ultimate AR-15" this is the receiver for you.

Pictures:
LEFT SIDE

RIGHT SIDE

FRONT QUARTER VIEW

REAR VIEW SHOWING REAR TAKE DOWN PIN SPRING AND DETENT RETAINING SCREW

LOW SHELF

BOTTOM VIEW SHOWING EDM MAGWELL AND UPPER RECEIVER TENSION SCREW

I built this lower tonite and dropped my personal Larue Stealth Uppered SPR-M with my SPR-M Barrel setup for my Ops Inc. silencer.

The STEALTH fit perfectly without using the tension screw.

Building the lower was no drama. Went together like a forged standard lower. MIAD fit just fine.

I did have to clip a couple of coils off the rear detent spring, set screw I taking up a bit of room I guess. I got it in full length but then couldn't move the take down pin.

Spec's are excellent. Timney trigger dropped right in. Just really no drama.

I wish I had ordered more but I didn't think much of Mr. Obama when this was being planned,

THIS PRODUCT REQUIRES AN FFL. PLEASE HAVE YOUR DEALERS FFL FAXED TO 816 221 1171 AND INCLUDE YOUR NAME AND/OR ORDER NUMBER WITH THE FFL.

$264.95