| | |
|
| |
| | |
|
|
KNS GEN II NON-ROATIONAL HAMMER/TRIGGER PINS
|
|
Manufacturer: KNS Precision, Inc
Product Options
|
|
This is the hottest setup we have seen for hammer/trigger pins. These pins are made of stainless steel with holes for lube. The pins are threaded on each end. These are available in three diameters, .154 for standard use, .155 for a tighter fit or receivers with wear in the pin holes and 3rd size is .170 for large pin Colt lowers.
Once the pins are in place in the receiver you simply place the pin retainers over the threaded holes in the pins and secure them with the screws provided. Once installed your hammer/trigger pins will no longer rotate and cause un-necessary receiver wear and the pins also cannot walk out to due weak hammer or trigger springs.
The little bullet shaped object in the picture is the EZ install tool and is screwed into the threaded end of the pins. Due to the taper on the EZ tool pin alignment is a snap. All necessary tools come with the kit.
They eliminate receiver wear, have superior ability to hold lube, stainless steel and are anti-walk.
Standard, Oversize and .170 Sets Available.
|
|
|
|
|